Provides 8 scan points with 48 volts and monitors saturation of those contact closures.

No saturation will cause the illumination of 8 large green LED's that indicates normal operation.

Saturation of any scan point will cause that channel's green LED to turn off and illuminate a large red LED indicating an alarm condition.

If any Scan point is in alarm mode (RED) then the Panel Alarm's LED will flash on and off and an audio alarm will sound. (note: this Led is on the right hand side of the box)

Once the audio alarm has been activated it can be turned off by pressing the Alarm Mute button.

There is a test button to verify that all LED's and audio circuits are working.

When a panel alarm is active (any scan point saturated) then an Auxiliary Relay is activated to transfer the alarm condition to another location.

The two wire scan points, power contacts, auxiliary relay contacts, all have connections on the top of the box via screw terminal blocks that can be unplugged for a quick disconnect.

The Detection Panel is powered from -48 volts and has connections for both A and B supplies.

The scan points are powered from internal ISOLATED power supplies so that no equipment is tied together electrically when connected to the scan points.

A backing plate connects to the bottom of the box and has a swivel mount to a mounting plate that is attached to the wall. This will allow the alarm Detection Panel to be wall mounted and adjusted for optimal viewing angle.